Welding question

[kroberts]

I have a new Stromung muffler and I need to modify a small support strap across the back of the pipes on it. The part is stainless steel. I have a 120v Hobart mig. I know this is probably an elementary question for trained welders however I am not one. Can I use general purpose wire for a small weld on SS? The part is about 1/8" thick and I have access to all sides.

Thanks

[hoveringuy]

I used my Lincoln 110 mig on the OBDII stainless header without any problems. No gas, shielded wire. A little more spatter than mild steel but still a good weld. You should have not problem unless it's much different alloy than the stainless on the OBDII headers.

[whowhatwhere]

Go for it, it wont pass an aerospace test, but it will hold fine for a muffler hanger.

[kroberts]

Thanks lads!