My Hvac panel won't stay flush against the rest of the dash. I can't find out what's holding it in. Is it a clip?
-
-
2 screws on top behind blank covers/switches, and two on the bottom, above the ash tray, you can feel them with your fingers.Last edited by Jean; 08-05-2008, 10:02 PM.Mtech1 v8 build thread - https://www.r3vlimited.com/board/sho...d.php?t=413205
OEM v8 manual chip or dme - https://www.r3vlimited.com/board/sho....php?p=4938827 -
I'll go check it out real fast..
Comment
-
I can't find them? Took my radio out and popped the switches out and everything..
Comment
-
when i removed my panel to change the bulbs, i noticed it would not go back in, so if you check those screws, they are up there, just use a small flashlight and see if you can look underneath. however if you check those screws and get those in there pretty good, my aftermarket stereo cages was holding it out just a bit. it seems one of the mounting tabs on the cage bent down to stop the panel from going back all the way in.1991 318is --- currently not road worthy
1991 318i ---- 308K - retired
Originally posted by RickSloan
so if you didnt get it like that did you glue fuzzy oil to the entire thing?Comment
-
I fixed it.
Comment
Comment