Selector Shaft Removal

[Apex381]

How do you remove the end of the gear selector shaft that is connected to the tranny? I've got the end that connects to the shifter free.

[Jordan]

Pull the grey locking ring off, and drive out the retaining pin.

[DanGillan]

hehe,,, i just did this... take off the few bolts that hold on the tranny underneath the selector rod, that will drop the tranny and extra inch and a half to give you some extra room, then you need to pull off the e-clip. there is a special tool for it, but I just did it with a hook tool. then it should just pull out.

[Apex381]

I see, whats a hook tool?

[Jordan]

I see, whats a hook tool?

You aren't done yet? just use a small flathead.