Aftermkt Gear knob and handbrake handle

[Spinning Tires]

I wouldnt twist unless you plan on never using your old knob over again

[Stevie30]

I honsetly dont think he is taking any of you seriously. $5 say's he screws this up in some fashion. Any takers?

I'll bet $5 that you made a good bet.

[Spinning Tires]

I bet he's still looking for the set screws while punching himself in the balls

[norcalE30]

I wouldnt twist unless you plan on never using your old knob over again

hahahahahahahahahahahaha

[Spinning Tires]

theres plastic shit in there that keeps the shifter from spinning in circles after you put it on. kinda defeats the purpose of trying to spin the knob while its still attached

[RRRR]

anymore kind advice before i stab meself with the knob....

[Spinning Tires]

just rip it off

[Thighs]

just pull hard as shit. if you dont hit yourself, wheres the comedic value?

[RRRR]

ok, will attempt yanking it off this weekend and update the comedy if it happened :pimp:

just pull hard as shit. if you dont hit yourself, wheres the comedic value?

[Knockenwelle]

It's inevitable. Like how a knife is not yours until you cut yourself with it.

[RRRR]

guys

wat about the handbrake handle? how to remove and replace....

[kronus]

guys

wat about the handbrake handle? how to remove and replace....

pull up the boot and cut the zip tie. It should slide off then.

[NC325iC]

ive never hit myself pulling the knob, put it in 2nd and pull up with a bit of a twist, pops right off with 1 hand

[Spinning Tires]

The E-brake Handle just pulls off too. you have to pull hard and twist also