Hi all,
Yesterday when I was done working on my engine, I closed the hood, but noticed that the passenger side roller guide did not sit right, so I would have to push it down to put it in the notch. Upon further inspection, the roller guide seems to be catching on a metal pipe that may have been bent out of place next to the passenger side notch. What should I do? Not sure what the pipe is for, not trying to break any important lines on accident.
Also, how would I get my hood to pop out when I pull the hood release mechanism? Right now It pops but I have to go to the front of the car to first pull it out, and then lift the hood up. Would replacing the strut do that? Or is there a separate spring or strut I need to do something to?
Yesterday when I was done working on my engine, I closed the hood, but noticed that the passenger side roller guide did not sit right, so I would have to push it down to put it in the notch. Upon further inspection, the roller guide seems to be catching on a metal pipe that may have been bent out of place next to the passenger side notch. What should I do? Not sure what the pipe is for, not trying to break any important lines on accident.
Also, how would I get my hood to pop out when I pull the hood release mechanism? Right now It pops but I have to go to the front of the car to first pull it out, and then lift the hood up. Would replacing the strut do that? Or is there a separate spring or strut I need to do something to?
Comment