clavinZERO's 5-lug swap with *PICS* and details galore!
Collapse
X
-
Still undiagnosed. I have been too lazy / busy to get in there and check the wiring out again. I have only locked them once so... I am not too worried about not having it. But still, not having the ABS dash light come on intermittently would be nice. I'll post up when it's sorted out... like wiring colors for the sensors and such. -
-
The Z3 rear arms were 150 each from Bavarian Auto Recycling. Their calipers were 50 each. Plus shipping, naturally.Leave a comment:
-
great writeup! Would you mind sharing where you sourced the trailing arms and how much they set you back?Leave a comment:
-
Jordan, that's what I did, but I wired the E36 stuff to the front... I have e36 front sensors and e36 front ABS pusle rings, and e30 rear sensors and e30 rear ABS pulse rings. My light still comes on intermittently... so I still need to figure things out. I know yours (Jordan) had matched pulse rings front and rear... but what about your sensors? All e30 or mixed like mine?Leave a comment:
-
I spaced my rear e30 sensors off the MZ3 trailing arm with copper crush washers and a longer allen bolt. Worked perfectly.
Leave a comment:
-
was he running E30 sensors/axles on Z3 rear with E36 sensors on E36 fronts like me?
thx for the additional input man.Leave a comment:
-
Get a scope, put it on each wheel sensor and make sure all the sensors put out the same signal by spacing everything with washers. That's how my co-worker did his. He said the rears are super sensitive, while the fronts aren't. But that thing did brake a WHOLE lot better than it did before, even improved the ABS functionalities.Leave a comment:
-
the nuts are already that funky squished "locking" kind... I just think it wasn't tightened at the alignment shop. But I will look into that Tony.Leave a comment:
-
use the paste thread lockers, works much better than the liquid/gel type.Leave a comment:







Leave a comment: