Hear a clanking from the front drivers side and when it was lifted noticed that sides ball joint was hanging lower than the other. I assume it is loose and need replacing. I'd like to replace them with perfromance parts to allow better cornering. So I need some sugggestions. What parts to replace while I'm there that I can justify $$ wise, etc. Here's the rub...I can't lower the car as we live on dirt roads in NM and clearance is vital. Also, the crappy roads here are the reason the ball joint went out ( I assume) as the PO had them done right before I bought it a year ago.
1. Need suggestions as to what type of ball joint set up to use
2. Parts to replace while I'm in there
3. Car must remain stock height but corner better than stock
4. How to "beef it up" so it won't happen again on crappy washboard roads.
Suggest away...
1. Need suggestions as to what type of ball joint set up to use
2. Parts to replace while I'm in there
3. Car must remain stock height but corner better than stock
4. How to "beef it up" so it won't happen again on crappy washboard roads.
Suggest away...
Comment