So I am in the process of installing my new struts, shocks and my new springs. The original front springs were cut so my new HRs are taller. I’m running into an issue(among many others lol) where I don’t know how to get the ball joint stud in to the strut assembly. It might just be an idiot not think but I’m clueless. Any help would be appreciated.
Announcement
Collapse
No announcement yet.
Help on installing the balljoint?
Collapse
X
-
Originally posted by ThomasE30 View PostI did think about disconnecting the sway bar from the control arm to get more room.
Put the ball joint spindle in its spot, then use a floor jack to apply pressure so you can tighten the nut without the spindle spinning.
There are a lot of situations where spending 5 minutes removing extra stuff will save an hour of struggling/breaking shit, this is definitely one of those situations.sigpic
1987 - 325i Convertible Delphin Auto [SOLD], 325i Convertible Delphin Manual [SOLD]
1989 - 325i Convertible Bronzit m30b35 swapped [SCRAPPED], 325i Sedan Alpine Auto[DD]
1991 - 325i Coupe Laguna Manual [Project], 535i Sedan Alpine [SCRAPPED]
Comment
-
So It ended up working and then i spent about two hours like an idiot forgetting that a ball joint can move. Finally just pivoted the ball joint at an angle for it to go in the hole and everything worked out great. Now the only issue i have is getting the brakes back on because the pads are going out too far now like someone is pressing on the brake. From what Ive heard you just have to compress the piston with a c clamp?
Comment
Comment