If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I've herd about doing a "big break kit" using e36m3 rotors and calipers. I also here there is a guy who makes the conversion kit. courious if any one can steer me in the right direction.
how do you not know how to spell "brake" properly...?
SC*AR
Originally posted by JamesE30
And with a car looking like yours I imagine the balance shall tip in the favor of insult, like a big fat fucking retarded fucking black girl on a see-saw, opposite... a dwarf.
That's the first indication that he should not attempt it.
to my knowledege most people that work on cars arent always good at spellin and school related things. sits on you computer and but a fucking asshole. must make you feel great.
Guys stop being jackasses. His grammar/spelling isn't the worst I've seen.
I don't know about using M3 calipers and rotors. remember m3's are 5 bolt so right away the rotors would not work. The most inexpensive BBK that I know of is using RX-7 calipers and vw corrodo rotors. Its not so much a BBK more a vastly-superior-caliper-and-pad kit
I don't think I'd want to use M3 calipers because they are of a floating design-> not very good for performance applications.
You could also contact Lee at Massive, I've heard very good things about his kits, although they are quite pricey. He is also the only one I know who carries BBK for the rear axles.
to my knowledege most people that work on cars arent always good at spellin and school related things. sits on you computer and but a fucking asshole. must make you feel great.
Get over it dude, this is r3v. If you can't take a joke then you shouldn't be here.
Originally posted by LJ851
I programmed my oven to turn off when my pizza was done, should i start a build thread?
Comment