Rear subframe Bushing HELP!!

[ADCD875]

I replaced my rear subframe bushings with PowerFlex bushings. Took me couple of months to finish (I had to go out of town for work). I tried to put it back together but I can't figure out where those large washers go. I put them between the bottom of the bushing and the bracket that also bolts to the body. Now it seems like the whole subframe is raised and the rear of the driveshaft is touching the fuel tank.

Can someone explain me whether I should re-use these large washers or not. And where they should go?

Any help is greatly appreciated..

[monty23psk]

big washer goes between top of bushing/subframe and chassis.

[AndrewBird]

^^^He is correct.

http://www.realoem.com/bmw/showparts.do?model=1113&mospid=47309&btnr=33_0213&hg=33&fg=30

[bwawuz02]

just did this...

Used a 5/8 bolt and tap. Tapped the stock bushing, tried using a slide hammer... no luck.

Threaded 5/8 bolt into bushing sleeve and smashed it back and forth with a 4lb sledge hammer wiggling it loose, worked like a charm.

too bad the auto hobby shop (place with lifts on military base) closed before i could put it all back together :hitler: