I made this tool:
It just a couple of nuts welded to a piece of 5/16" steel, and spaced to fit the slots in the bushing:
I broke it loose with just the nuts, and then put bolts in to extend the reach when I clamped it in a vise:
As you can see, I'm only putting pressure on the rubber mounted center sleeve. It didn't move until I heated the outside with propane. Once it moved, I used the longer bolts to finish the job.
It just a couple of nuts welded to a piece of 5/16" steel, and spaced to fit the slots in the bushing:
I broke it loose with just the nuts, and then put bolts in to extend the reach when I clamped it in a vise:
As you can see, I'm only putting pressure on the rubber mounted center sleeve. It didn't move until I heated the outside with propane. Once it moved, I used the longer bolts to finish the job.
Comment