Garagistic pedal bracket with cable balance bar adjuster knob

[P Arkus]

Anyone here running a wilwood pedal set using the garagistic bracket? I'm doing an M60 swap in mine and going boosterless so I bought the wilwood cable balance bar adjustment knob. Only issue I see is that i'm going to have to dremel out quite a huge notch in the garagistic bracket to allow the brakes to properly engage with the cable attached to the balance bar. Has anyone else run this setup and gone a different route (found a way to get the cable on there without notching the pedal bracket)?

Any input would be greatly appreciated!

TIA!

[SkiFree]

I would think a rather specialty piece like this would have plenty of customer support during setup. What did garagistic recomend in your case?

[jpod999]

Daniel did exactly this on his build: http://www.r3vlimited.com/board/show...&postcount=221

[P Arkus]

Hmmm thats what I figured. Still waiting to hear from Garagistic on what they recommend. Thanks for that link Jpod!