spring rate

[619E30]

I'm 440f/625r and it's wayyyy too soft for my liking. Be sure to share your thoughts on those coils. Was always curious how well they rode.

[immajackuup]

was about to go with those rate but I did some hard research about people keep switching to 500/750 rate.

[E30_fiend]

Im on 600/750 and I love it.

Also, I hope you understand those BC's arent just a bolt in coilover. Just FYI if you didnt already know.

Its actually a lot more involved that you'd think


Taylor

[immajackuup]

Im on 600/750 and I love it.

Also, I hope you understand those BC's arent just a bolt in coilover. Just FYI if you didnt already know.

Its actually a lot more involved that you'd think


Taylor

yeah i already know that,heading to the junkyard this weekend to get a pair of strut housing.

[einstein57]

5.5inches in front and 4inch rear,cutting the strut housing to 1inch instead of 2 which will let me go another inch lower.

I'll let you know how things go when I receive my coilover.

From the install threads i've read the 2" at the bottom is to center the sleeve that you weld on. It slides over and you actually weld to the very bottom of where the strut tube meets the spindle. So you'd have to cut the BC tube 1" shorter as well in order to achieve the result your looking for.

[immajackuup]

no,if you cut the oem housing to one inch the sleeve can move down more which is why i order shorter spring to have more sleeve.

but I'm not looking to slam my car to the ground because of horrible streets in Houston.