Has anyone installed OEM E36 M3 springs in to their E30?

[kickinindian]

Bump for this pics?

Sent from my VS930 4G using Tapatalk

[rwh11385]

I rode in a '90 e30 325is with stock m20/g260 and E36 M3 springs installed with bilstein e30 dampers.

It was lower, rode nice. thought it was stock for a moment and then it looked to low.

0 details of install; was my friends car.

pics?

[Wanganstyle]

Ask google

[rwh11385]

Ask google

I did. It was what directed me to this thread: http://lmgtfy.com/?q=E36+M3+springs+in+an+e30&l=1

Most on the intratubes just speculate that it'd raise the rear end, so a disconnect with your statement and would be helpful to see it or know more... since dropping E30 rear ends is the easy way to pick up additional negative camber.

http://forums.bimmerforums.com/forum/showthread.php?821527-Would-E36-Springs-fit-on-an-E30&p=10518727#post10518727

Car in front has E36 M3 springs

[BlackbirdM3]

I'd love to try this if there were a set of E36 springs that were a higher spring rate than the E30 H&R race springs. I want to raise my car up to get the suspension geometry correct, but I also want more spring rate. Right now I have the E30 H&rs and the car is a little soft, and sits too low. I'd like to bring it up about half to 3/4 of an inch. I've been looking all over google for info on the E36 to e30 spring swap but haven't found much useful info.

Will