Cabrio Suspension upgrade

[Bmwb]

just wanted to see if this setup will still work on my cabrio or not , also considering advice on a quick cheap way until i have money for a bbk setup what would be good i am turboed aswell so im gonna need some better brakes which should of been my main concern

i ended up getting my bmw 325is back the previous owner put alot of money into the suspension i wanted to know if i will run into any issues due to me swapping it onto a cabrio

-Dinan Engineering negative camber plates
-Dinan Engineering anti-roll bar front and rear
-bmw e30 m3 front control arms
-e30 m3 offset control arm bushing set
dinan does not sell these parts anymore after doing research
-D190-0363 stage 3 is all the paper says i couldn't find out what it was but im pretty sure it was for the rear
-D170-1050 2002 camber kit
-d172-0900
-d172-0902
-d172-0903
and a set of adjustable koni shocks
pretty sure springs are h & r

[Ether-D]

All will work fine. I believe.

[Bmwb]

I looked everywhere I'm on my phone searching can aluminum ball joints be pressed out and replaced I purchased new ball joints from napa which said I am able to when I took them to the mechanic to replace he said he could only rip the guts out but couldn't take the outer part off and replace it

[Ether-D]

I bet on the aluminum control arm ball joint replacement, it's a no go. Not sure, just an educated guess.

[Bmwb]

not to sure trying to find out like i said guy at napa said you can sold me 2 inner ball joints

[Ether-D]

You can with the cast iron control arms. I think he's mistaken.