I'm trying to install my front UUC sway bar but I'm running into a problem with mounting the brackets.
From these instructions I'm getting that I would use the original bolts for the front bolts that hold the from subframe/cross member in, which is scary since I loose a lot of thread on the bolt after adding the bracket hardware. Then I would use the smaller bolts that were included in the kit for the rear.
Further more, even if there was enough thread on the bolt, the flat bracket's holes are too small to fit the front subframe bolt through.
So, where do I go from here? I feel like I'm missing something here or not understanding the install instructions. The rest of the hardware is correctly installed on the sway bar / end links and I'm only left with two bolt and nuts... I would need four if there were new ones for the subframe.
:thankyou:
From these instructions I'm getting that I would use the original bolts for the front bolts that hold the from subframe/cross member in, which is scary since I loose a lot of thread on the bolt after adding the bracket hardware. Then I would use the smaller bolts that were included in the kit for the rear.
Further more, even if there was enough thread on the bolt, the flat bracket's holes are too small to fit the front subframe bolt through.
So, where do I go from here? I feel like I'm missing something here or not understanding the install instructions. The rest of the hardware is correctly installed on the sway bar / end links and I'm only left with two bolt and nuts... I would need four if there were new ones for the subframe.
:thankyou:
Comment