Loose springs - IE3
Collapse
X
-
if springs pop out from something like a speed bump, the valving is dead
stage 3's with stock pads sit tight enough to not be able to come loseLeave a comment:
-
My springs never popped out of the hats when the weight of the car was on them, never even came close. The only way I could see this happening is if you jump the car. Every e30 I've seen with IE's or any other significant drop had a gap when you lifted it up.How is this normal by any means? I've seen vehicles (e30's included) that if they hit a speedbump, pothole, etc can cause the spring to pop out of the hat really easily.
The shock should be matched properly to keep the spring under a LITTLE tension when unweighted.
my
Leave a comment:
-
How is this normal by any means? I've seen vehicles (e30's included) that if they hit a speedbump, pothole, etc can cause the spring to pop out of the hat really easily.
The shock should be matched properly to keep the spring under a LITTLE tension when unweighted.
my
Leave a comment:
-
Try putting in Turner's Jstocks lol. There is about a 2-3" gap at the top between the springs/spring hat before you set the car down.
WillLeave a comment:
-
I remember thinking the same thing when I first installed my IE's in the back, since they're so much shorter, when we put them in, they didn't reach top to bottom and I was thinking, "are they supposed to be like that?"Leave a comment:
-
Thanks. That is what I thought. It has just been a few years since I looked at them that closely and it kinda freaks you out when you are taking the car to the track.
:up:Leave a comment:
-
Both my car's are like that untill they are back down onto the ground. It is just because the springs are so much shorter than stock.Leave a comment:
-
Loose springs - IE3
So I had my car up on a lift getting my tech inspection done when my buddy doing the inspection pushed up on my front tires to inspect the bushings etc in that area. He heard noise of metal on metal that sounded loose and we both thought "wtf?". we dropped the car down a bit and looked closer to notice that my IE3 springs are i guess you would say loose in between the top and bottom holders. I cannot remember from installing them, but both sides are the same and the top nuts on the struts are tight. Is this normal? I know the metal on metal is cause I have no spring pads, but there was a lot of room down there. I just want to make sure this is normal.Tags: None

Leave a comment: