If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
OK for the supply and return lines, but if the pressure hose is leaking, replace it with the real thing.
Yea, I'm doing it on the return and supply lines NOT the pressure hose. For whatever reason the pressure hose is bone dry, but the other hoses are super leaky. Good for me.
trans mounts, oil pan gasket, motor mounts, trans outpus shaft seal, shift shaft seal, guibo, Center mount bearing, fuel filter (original! 133k lol), radio, winshield washer "T" AAANNNNNDDDD power steering hose clamps
all replaced
7 hrs, broken back
and yes, hose clamps will work fine, its just messy as fuck and a bitch to get the old ones off
I disconnected from bottom points, lifted res up, clipped off clamps, replaced with screw type
trans mounts, oil pan gasket, motor mounts, trans outpus shaft seal, shift shaft seal, guibo, Center mount bearing, fuel filter (original! 133k lol), radio, winshield washer "T" AAANNNNNDDDD power steering hose clamps
all replaced
7 hrs, broken back
and yes, hose clamps will work fine, its just messy as fuck and a bitch to get the old ones off
I disconnected from bottom points, lifted res up, clipped off clamps, replaced with screw type
Ok, so you didn't replace the hoses, just the clamps....ok.
Comment