will these fit my 87 325is directly?

[e30loverSC]

http://cgi.ebay.com/ebaymotors/4-NEW-16x7-4x100-MBMotoring-Mesh-X-Wheels-Rims_W0QQcmdZViewItemQQhashZitem53dcb8fd66QQitemZ360185396582QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

Will these wheels fit our cars? or will i need spacer if so what size? and what tire size is recommended for the fit?

[IRON-E]

anything 4X100 is a direct fit for the e30, unless the center bore is different you're good to go. You may want to run a 15mm spacer up front and 20mm in the back for the close to flush fitment.

Good luck

[e30loverSC]

ok thanks i appreciate it. Without spacers will they rub? And should i not run 15mm alll the way around?

[e30loverSC]

??

[Philo]

You will most likely need spacers and will definitely want them. I would do 20mm up front and 25mm in the rear. The rear needs a little more than the front to look flush.

[e30loverSC]

damn i really need that big of a spacer? and what tire?

[daniel]

15-20mm spacers all around, 205/50-16 or 225/45-16 tires.

[constructor]

damn i really need that big of a spacer? and what tire?

15-20mm spacers all around, 205/50-16 or 225/45-16 tires.

Correct.

If you want to use a stock height tire like the sizes mentioned above and don't want to roll your fenders, 16x7 ET25 with 225/45-16 is the biggest wheel and tire combination you can run without rubbing on the fenders or the front struts.

The wheels you are looking at are ET38. A 15mm spacer will get you to ET23 which should be fine. If your fenders are rolled, go 20mm to get the a bit more flush.

[e30loverSC]

this may sound dunb as hell but what do you mean roll my fenders and who can do that?

[IRON-E]

this may sound dunb as hell but what do you mean roll my fenders and who can do that?

You must search my GRASSHOPPA. ;)