If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Brock B1's, 16x9, et15. They stick out past the fender about an inch. I know it'll be a tad less when sitting down, but still. Could rolling and maybe a little pulling get these to work?
Well of course, I can see that. Hah. But I've seen many others running this size wheel with stock fenders (no flares, or excessive pulling) and they don't poke that much? I mean it looks like I'd need to build some flares or something to make these fit.
I'm on ST springs and Bilstein sports, its about as low as H&R races I think. so I think I can make em work with no camber. 215/40/16s should do the trick.
They'll look totally different dropped on the ground with a tire.
My buddies swore my 17x9 ASA wheels wouldn't fit my 5 lug car but even with a 20mm spacer on the front, 235 tires, and the coilovers all the way down they are no problem. :)
I have a 5 mm spacers, slightly pulled fenders and 245/15/16. No rubbing whatsoever.
If i go low enough the rim sits inside the fender. So yes, they will fit no problem.
Your not gonna have a problem once it's on the ground. I have the same wheels and they fit no problem with 225/40/16s.
Some people even run spacers with their ET15s and all they need is a roll/smaller tires.
Comment