Well I got a problem....as usual.

[DanR]

Local guy here had a set of volks machined down to change the offset.

[3two8eye]

Do they happen to have centers that are mismatched? If you aren't going to buy them I am very interested. but I doubt he would sell one center. Are they 15 inches and 5x130?

They are definitely 5x130, but I think they might be 16s. I have to figure the offset and I may have adapters made up. What are the complete specs of your wheels? And adapters? What's the final offset and clearance?

[hootie]

They are definitely 5x130, but I think they might be 16s. I have to figure the offset and I may have adapters made up. What are the complete specs of your wheels? And adapters? What's the final offset and clearance?

The rims I have are 15 inches.

Fronts: 15x8 with et 35
Rears: 15.8.5 supposedly with et45 but one has a 62 mm frontface to hubface and the other has a 42 mm frontface to hubface

I had 20 mm adapters on the back which set the rears off perfectly (well the one rear that was out a little more) and the front looked damn good too (still on the car because i need tires on the D90's)

I PMed you about the 20 mm adapters I have for sale.

Hootie

[euro3]

Longshot

Did you check to see if the wheels are assembled the same way? Possibly one of the centers was installed wrong. (not front and rear, but the actual assembly of each wheel)Normally the center part is sandwiched between the inner and outer barrel........is it possible to mix that up.

I can't view the pictures(at work) but if they are staggered then double check the measurement of all inner dishes and all the outer dishes.

I recently assembled a set of RS070/RS071s. I was amazed at how many different ways I could assemble them.

G/L