Announcement

Collapse
No announcement yet.

Pop out quarter glass?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Pop out quarter glass?

    Anyone know if we can mix&match the coupe hinges/seals to retro fit pop out glass to the touring? I'd imagine we'd have to drill the glass for the rear latch, but what about the front?
    My feedback:
    http://www.r3vlimited.com/board/showthread.php?t=186328

    http://e30tech.com/forum/showthread.php?t=74911

    Instagram:
    @gears_n_glory

    @functionmotorsports

    #2
    never seen it but that would be awesome

    Comment


      #3
      has it been verified that they've the same dimensions?
      -89' 320iT, Brilliantrot
      -15' 320i, Glacier Silver Metallic

      Comment


        #4
        I think you might be able to use the hinge/latch, but would have to cobble the rest together.

        If you note, the C pillar on coupes is slanted forward, whereas the touring is reversed. It could well be that the touring has essentially the same glass at the rear/D pillar.

        Comment


          #5
          There's a thread on here that referenced some images of a touring with them installed. Images are now dead of course, but is apparently a possibility.

          post 220 and below for reference: http://www.r3vlimited.com/board/show...242413&page=15

          Anyone know a Winston?
          '89 318i Touring
          '90 Miata

          Comment


            #6
            I think this would be pretty cool, I'll measure my dads touring windows and my coupe windows next time they're side by side.
            My Garage
            2001 Z3 2.5i Steel Gray/Black (Lexi)
            1988 325ix Diamond Schwartz/Black (Izzy)
            1989 325i Cirrus Blue/Houndstooth (Stitch)
            Feedback

            Instagram: Stone.Hopkins

            Comment


              #7
              Still digging up info but:



              and FINALLY a picture of one with pop outs:

              '89 318i Touring
              '90 Miata

              Comment


                #8
                more info from Jozi's thread.

                Seems like you just need to fit the seal, rear latch and front anchor. From what I gather, the tough part is getting the glass and trim off without destroying them. Very risky task, being that we don't have access to that stuff. Trim and clips are NLA and as far as I know, we can't get the quarter glass; we'd need to pay someone to remove it without breaking it....
                My feedback:
                http://www.r3vlimited.com/board/showthread.php?t=186328

                http://e30tech.com/forum/showthread.php?t=74911

                Instagram:
                @gears_n_glory

                @functionmotorsports

                Comment


                  #9
                  All this is before considering that turbulence in the cabin could well be awful with pop outs in that location. It would be a shame to do all that work and have it effectively useless.

                  Seems to me that the more worthwhile effort would be installing rear power windows, as they are very difficult to reach (off side impossible) without pulling over.

                  Comment


                    #10
                    My car is a non-AC & slick top.. Just having the rear windows cracked is not nearly enough to properly evacuate hot air.
                    My feedback:
                    http://www.r3vlimited.com/board/showthread.php?t=186328

                    http://e30tech.com/forum/showthread.php?t=74911

                    Instagram:
                    @gears_n_glory

                    @functionmotorsports

                    Comment

                    Working...
                    X