Does anyone still sell Mtec1 Spoilers?

[32.5i]

These would be cast in rubber with a urethane insert and retain every aesthetic detail from the stock Mtec1 spoiler - including the grooves in the lip.

e30 MTechI had no grooves

e28 MTechI had grooves

[IRON-E]

e28 with e30 mount holes. as long as its not fiberglass

^^^this^^^^and for reference here's my e28 wing on my IS




and my buddy's Mtech 1

['90 325is]

definately down for this. e28 one looks sick, as long as fitment is correct

[Moto-Mucci]

Nice pics, thanks.

I will most likely be casting them with the grooves - unless there is a strong objection.

I figure if you don't want the grooves you can sand them out easier then it would be to sand them in.

[Moto-Mucci]

New Thread: http://www.r3vlimited.com/board/show...57#post1495257