Announcement

Collapse
No announcement yet.

Need a clutch! Suggestions????Please help!!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Need a clutch! Suggestions????Please help!!

    So I replaced my lsd and now its the clutch too so I need a complete kit. Any suggestions as to wich one for a dd/track car just sometin so I can get to school and back without killin my leg but also giving me better than stock. Anything else I should upgrade/replace while I'm there?
    Thanks so much any input is welcome!!

    #2
    anyone???? I really need to figure this out

    Comment


      #3
      Just get a OE replacement.
      1985 325e 2.8 Turbo VEMS

      Comment


        #4
        I want to upgrade while Its out

        Comment


          #5
          What are you puting it in? 325e 325i? A stock clutch can hold very well.

          Comment


            #6
            1991 318is

            Comment


              #7
              M20 single mass flywheel and clutch will be a upgrade.

              Comment


                #8
                Why do you feel you need to upgrade? Unless you're running some crazy turbo setup or an engine swap, a stock clutch will work just fine. I'm sure plenty of folks on here that DD, auto-x, or track their cars use the OE clutch as well. I do.
                -Geno

                '87 325is (s52'd)
                '95 525iT
                '02 Range Rover 4.6 HSE
                '98 Disco 1

                Comment


                  #9
                  I already have an m20 flywheel so does the m20 clutch disks, pressure plate and throw bearing bolt right on?

                  Comment


                    #10
                    and its not that I feel the need to upgrade I just wasnt sure what my best option was

                    Comment


                      #11
                      Originally posted by ediaz029 View Post
                      I already have an m20 flywheel so does the m20 clutch disks, pressure plate and throw bearing bolt right on?
                      Yeah its direct swap. People use the M20 single mass and clutch for M50 swaps along with the 240 trans. Everyone says you need a euro 323 TO bearing but when I searched the M20 single mass and the euro 323 have the same part number on realoem.com

                      Comment


                        #12
                        PM sent

                        Comment


                          #13
                          just curious, but does the new flywheel have to be balance matched to the old one?

                          Comment

                          Working...
                          X