need quick help

[der affe]

i just did an 95 M-3 rack swap and one of silence's P/S deletes. getting ready to do the toe.

what do you set the toe at?

zero?

how much in ?

how much out?

it is a street car i drive fairly hard.

thanks in advance

Greg

[der affe]

well i set it to dead zero toe, we'll see how it does.
any one else set their own toe?

[2002maniac]

I like 1/16" toe in. Zero toe is good, but wanders a bit on the highway

[der affe]

thanks, zero was a bit hard to steer too.

[Nic01101011]

i set my own toe last time, and went with 0 toe.
what technique are you using?

[der affe]

outside of center rib to same on other tyre. first measure front then back of tyre. figure out difference and adjust to acheive desired effect.

i was going to make some quick toe plate but i ran out of time and light.

taking it to my friends shop in a few days for an actual alignment on a rack anyways, but this should get me by.

[z31maniac]

0 toe here as well.

[FredK]

0 toe, needles and string (this is r3v). No wandering or tramlining with 225mm tires.

[nando]

I went with 1/16in, $50 for a laser alignment can't be beat.