New to the forum II: The Revenge

[daniel]

a 3.8L M20?

[accident]

7:1 ratio, no forced induction. Am i missing something here. If its all motor stoker, shouldnt it be higher in compression? Sounds good, let us know how the tang CS works for ya.

a 3.8L M20?

lol at not getting it

[TheB1G Lebowski]

Then what is it? Thanks.

[Rustyduktape]

its......... a.......... joke.............

[decay]

[TexasTerp]

I would think you need to use at least 40 head gaskets to get the 7:1 compression. don't forget to use Gorilla Glue to keep the monkey in place (and the head gaskets for that matter).

Enjoy and welcome to r3v!

[Massive Lee]

Did Whatt18yahoo open another account? ;)

[JasonC]

Welcome!

Nice avatar, i use the same one on an S10 site and F-body site.

[TheB1G Lebowski]

oh /lame.

[Jand3rson]

I like this guy already.

[ZombiE30]

I would think you need to use at least 40 head gaskets to get the 7:1 compression. don't forget to use Gorilla Glue to keep the monkey in place (and the head gaskets for that matter).

Thanks for the tip! My last monkey escaped and ripped my neighbor's roof in half after smoking a bunch of PCP.

However, I just spent a bunch of $ at pelican parts getting replacement fasteners and other maintenance items, so I don't think I can afford 40 head gaskets. :(

It's okay, though! I should be able to make up for the loss in power using the following blueprint:



note: It may look like I just drew this on MSpaint with a touchpad mouse, but it's actually a photograph. Those curves are designed so that it is undetectable by radar.

anyway, thanks everyone for the warm welcomes!