bav auto / IE / stock

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Adrian_Visser
    replied
    My m20 had blue bremi wires are those the IE ones?

    Leave a comment:


  • kronus
    replied
    BavAuto is the suck. The ones that came with my car basically crumbled apart.

    FYI the lifetime warranty applies only to the original purchaser.

    Leave a comment:


  • blunttech
    replied
    Originally posted by iwantspeed
    any other choices out there as far as aftermarket.
    im gunna make a choice soon

    just ordered a new stock coil
    i have oem karlyn sti's cheaper than anyone

    Leave a comment:


  • iwantspeed
    replied
    any other choices out there as far as aftermarket.
    im gunna make a choice soon

    just ordered a new stock coil

    Leave a comment:


  • der affe
    replied
    my car came with IE wires on it, i have had the car for over 5 years and OHM them periodically, they are all with in spec and have not changed each time i check them.

    Leave a comment:


  • iwantspeed
    replied
    Is Karlyn the same as bremi?

    Leave a comment:


  • Naplm00
    replied
    Ive got a set of good conditon stock E and I wires for cheaps

    PM for info

    Leave a comment:


  • Dirtbleed
    replied
    I'm running IE. No complaints.
    Attached Files

    Leave a comment:


  • gearheadE30
    replied
    I voted stock, although the only experience I have is with the M42. they are obviously high quality, there really isn't much performance to be gained there unless your wires are already really bad, and they don't have some garish insulator color.

    Leave a comment:


  • blunttech
    replied
    I have STI OE wires for the m20 on special this week. 130 bucks

    Leave a comment:


  • nando
    replied
    bavauto plug wires are shit. garbage. junk.

    mine broke right out of the box, one of the leads fell off before I even had a chance to put it on the car. A few years later one of the wires broke in half, I was pulling by the boot too not the wire. A couple other guys I know had severe arching from their bavauto wires, out of th ebox. I still have mine, but I cut them up to use with wasted spark coils. Someday I'll buy a decent wire kit and build a fresh set.

    I would build your own, you can take the impulse sensor from your old set.

    Leave a comment:


  • recall
    replied
    Do the bavauto wires not have the impulse sensor?

    Have you checked out magnecore? I'm looking for some too, and that seems to the the best bang for the buck, but again, no impulse sensor...

    Leave a comment:


  • iwantspeed
    replied
    how is this fitment comparing the ireland vs bavauto's wires

    Leave a comment:


  • browntown
    replied
    I think you'd be hard pressed to tell the difference, but if the aftermarket ones are marginally more expensive, go ahead and give them a try.

    Leave a comment:


  • delatlanta1281
    replied
    I have had my set of IE's for @ 5 years and they rule.

    Leave a comment:

Working...