Is anybody interested in an intake kit that will replace the high beam with an ITG filter? Advantages would obviously be no need for a heat shield and a larger and more direct volume of cold air than stock. In my testing just going to a more direct, larger diameter duct decreased IAT's by about 15 degrees. Having a properly shielded AND ducted intake can decrease intake temps by over 50 degrees when compared to your average cone filter setup.
I can do 3" or 3.5" inlet diameters and will use pre-bent tubes(not flex hose) to the AFM/MAF. ITG rates the 3" filter good to 310 BHP and the 3.5" good to 450bhp. This is a foam filter so it does an excellent job on filtering. There is a reason dirt bikes use oiled foam filters, they simply filter dirt way better then paper and gauze. I will do at least a limited run on this kit just to test the market, if these sell well I'll continue to stock them.
(I got bored with p-shop)
I can do 3" or 3.5" inlet diameters and will use pre-bent tubes(not flex hose) to the AFM/MAF. ITG rates the 3" filter good to 310 BHP and the 3.5" good to 450bhp. This is a foam filter so it does an excellent job on filtering. There is a reason dirt bikes use oiled foam filters, they simply filter dirt way better then paper and gauze. I will do at least a limited run on this kit just to test the market, if these sell well I'll continue to stock them.
(I got bored with p-shop)
Comment