Is there a trick for...

[KirkerBezerker]

How long do you guys think i will be able to roll on just three lugs with the 4th loctit'd on?

[KirkerBezerker]

I like the loc tite technique for sure! It is my rear drivers wheel.

[KenC]

Yeah, you stripped one. Buy a new hub... It's the whole hub/bearing assembly.

[Adrian_Visser]

Since you are most likely going to pull the inner race of the bearing out with the hub you better have the bearing on hand too. Front or rear wheel?

[Fusion]

Easier to just put some loctite on the back of the rotor. Just enough so that when you need to replace it you can just smack it with a hammer.

[KirkerBezerker]

So i would have to replace the hub and the bearing right?

[bmw325csi]

you probably need a new hub if it spins freely, you might be able to get away with re-threading but you would need a different bolt.

[KirkerBezerker]

Haha i dont have any of the tool kit. I guess i should probably look into getting one.

I was able to get 3 of the bolts to tighten down but 1 of them just spins anyone have this problem?

[KenC]

Use the alignment tool in the trunk tray.

[KirkerBezerker]

When you are mounting your wheel back onto your car, is there a trick to make it easier to get the holes in the rotor to line up?