Electric Fan Wiring Diagram

[ZekeTheSneak]

So after many days of countless searching i only found bits and pieces on this subject. So today i spend an hour writing this up on Rhinoceros. Since there are many ways to wire in a fan please only helpful criticism. If you see anything that is wrong please let me know. Also the new spal fan will operate when the A/C button is depressed. This has not been tested but will be very shortly with eric's motor swap (avery0829). Any questions feel free to PM.

[ZekeTheSneak]

disregard that part# just recieved mine it doesn't look right

[ZekeTheSneak]

61318361787 correct part #

[DaveSmed]

A lot of that is unnecessary.

Check this thread out, lots of good info.

http://r3vlimited.com/board/showthread.php?t=186860

[nando]

the pelican instructions are pretty clear. that thread is full of confusion. switching the wires is not a big deal at all - just connect both sides of the switch to the high speed circuit. done.

[ZekeTheSneak]

thanks nando, this is the way we did it with erics because he already had a relay for the spal so why not be extra safe, for mine I'm just using an 8 amp fan and using stock wiring with no relay. Forget paying 50 bucks for the fancy spal relay harness

[nando]

the stock wiring has a relay, two actually :p