Are these 14.5# injectors?

[hotballs]

http://cgi.ebay.com/ebaymotors/BMW-325i-325ic-325is-FUEL-INJECTORS-87-88-89-90-91-SET-_W0QQcmdZViewItemQQhashZitem3cb8e365f0QQitemZ260799948272QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories#ht_7801wt_1165

The only ones I've ever seen are light blue. Looking for cleaned 14.5s.

[devon.818]

ireland engineering sells new injectors.

you can get 17# ones that are NEW for 38 shipped

http://store.nexternal.com/ireland/f...lbhr-p328.aspx

[hotballs]

38 * 6 = $228

I'm ok with cleaned with flow test sheet. I have a set of 17s laying around but would cost $94 to clean them. Right now I'm just looking for some 14.5s already cleaned.

[TimR]

If there for the 84 ETA listed in your profile they use a different injector than the I motor, i've seen posts saying other later injectors will work but its something to do with the impedence, ones high, ones low but i've never tried it. His listing might be wrong, ETA injector 0280150126

[gtdragon980]

set of 6 rebuilt for 80 bucks, i bought mine from here! great quality!

http://www.fuelinjectorconnection.com/shop/index.php?_a=viewProd&productId=107

[TimR]

http://search.yahoo.com/r/_ylt=A0oG7...%2520Table.htm Stan Weiss fuel injector tables

[hotballs]

Don't worry about my profile, that is old. I knows what I'ms looking for.

[hotballs]

set of 6 rebuilt for 80 bucks, i bought mine from here! great quality!
http://www.fuelinjectorconnection.co...&productId=107

And they were light blue? or at least verified 14.5 lbs/hr?

Thanks

[nando]

ireland engineering sells new injectors.

you can get 17# ones that are NEW for 38 shipped

http://store.nexternal.com/ireland/f...lbhr-p328.aspx

that's $38 each, and they're backordered.

[TimR]

Check with this guy he may some sets sitting arround http://search.yahoo.com/r/_ylt=A0oG7...orservice.com/

[gtdragon980]

well IIRC, when i recieved them, i think they were grey. But i did call and verify with the reps that it is 14.5# and it is for our car.

And they were light blue? or at least verified 14.5 lbs/hr?

Thanks

[hotballs]

Thanks, so I did a little sleuthing. The Bosch part number for m20 14.5 injectors is 0280150715.

According to this table here.... http://www.injectorcleaning.co.uk/flow.htm ... it makes sense because that part number comes up having a flow rate of 155cc/min = 14.74lbs/hr @ 15.9 Ohm.

To get cc/min multiply lbs/hr by 10.515.

This should be in the tech section.