How to mount harness to roll bar

[Jafxod]

So I ended up with a harness that comes to a V behind the seat and then has a single bolt end like this but just one.



I cant find any pictures of how these are mounted. Am I gonna have to weld on a tab off the roll bar or could I drill through the bar and bolt it through there. Just wondering, cant find any info or pictures.

Thanks guys.

[Jaxx_]

usually harness bars attach to the factory seatbelt points on the b pillar.

I would put it on the roll bar if you have that option. I'm not sure what the best method of attaching it would be, however.

[Jafxod]

I do have roll bar

[kts]

http://www.hondaclub.com/forum/articles/4952-how-install-racing-harness-right-way.html

first few photos will show you how it's done. in the end you're basically replacing the D shaped harness bolt mount piece with the roll bar around the harness.

http://www.24hoursoflemons.com/userc...ntFriendly.pdf also has info about the proper way to loop your harnesses.

[KenC]

Take the bolt end off and just wrap it. Who lets you use a Y-harness??

[Simontibbett]

Yeah Y-harnesses are illegal pretty much everywhere.

Wrap around is best unless the chassis can accept otherwise... correctly that is.

[Jafxod]

Yeah I didnt really need a spec harness as I didnt believe I needed one for hpde and autox so I just ordered a used camlock one off ebay and assumed it was the loop around the cage kind.

[Jafxod]

Thats what Im working with.

[CHIF8008]

ya just weld the tab it came with

[Jafxod]

Didnt come with anything.

[jaywood]

Make your own bracket

Drill a hole through some flat steel and weld it on.

[CHIF8008]

^ +1 bam. done.

[Cronopoulos]

Make your own bracket

Drill a hole through some flat steel and weld it on.

Agreed, that or wrap the fabric around the bar and secure it that way.

[Jafxod]

Thanks dudes.

Just wasn't something I felt like guessing on. Now that I look into it these types of harness are still commonplace in racing.

[Jafxod]

One more idea.

Notch into the tubing, then drill a whole through the tubing and insert the the harness end into the pipe and then run a bolt through it.



Just trying to avoid welding as the bar is bolted into the car and I dont wanna set my car on fire welding with it in haha. My good welder is also 220v and located in my basement haha.