double barrel intake

[Wh33lhop]

Well it is interesting, i'll give you that.

[fporro]

- chance, aluminum gets too hot, pvc it's easier to manipulate for now.

- LJ851, we'll see., I know, read this and that, I know., it's for fun.

- delatalta1281, everyone complains how dbilas runners are too wide and that bog down feel and flatness, with sigle setup she's snappier, trying to play with resonance effect and so on. oem runners are 18", looking for something that's variable., thought that using 2" mains into 1 1/2" runners would recreate velocity stacks., she's on Alpha-N mode for that run.

- gtdragon980, yes, I get the irony in your pic, worst would be to sit on my ars and try nuthingz ;)

- ak, as soon as remapping is done, she should idle pretty well, or so i hope, it ran smooth with single set up.

[ak-]

lolol, how's the idle?

Looks like fun

[gtdragon980]

[delatlanta1281]

How would this be better than your Diblas intake plenum?

[LJ851]

Plenum area is much too small.

[chance]

I like the idea, but I would like to see it in aluminum.

[fporro]

So, I been screwing around again with PVC intake :) she runs well, i'll have to route cool air to feed them.

no, they have not melted nor cranck snapped, it's experimental fun.

I'm yet to finish MS2 tunes so she cuts off at 3800rpms and higher as I go into 2nd, 3rd etc., 4th gear cuts off aroun 5200 rpms
not the mani's fault as single unit did not cut off with W.A.R. chip. it's a 2" main to 1/ 1/2 runners.


this it what it look like now and then ...