Do we have an MTech 1 Thread?

[bradnic]

Details on the Metlzer part numbers on my coupe sideskirts - last bit is the mold date I assume. the numbers all match JMs
30 year old parts yo!

[2002jm]

thanks

Ok, I do not have vert skirts:). Will find out in the next few days if the driver side will go on easier by putting the back on first.....if it does will have to take the passenger side back off:(.
Which is all part of the learning process...right:)
Thanks for the pictures and help.....got the euroweaves on the car 15", so it looks so much better.
jm

[Old city bimmer]

These are mines

[Old city bimmer]

All glass out and absolutely no rust for 31 yr old window frames. Car is going to the paint shop tmrw. It will take a month.

[Mr. Wolfe]

Can't wait to see some new pictures!!

Mr. Wolfe

[2002jm]

side skirts

Well, I confirmed, at least on my car, the back of the skirt goes on first and then the front and then the middle part. Guess the front is more flexible and will 'bend' around the wheel well better than the back. Here are a couple of pictures. Now to take the rear valance off again and fix the brackets:)
jm

[Old city bimmer]

What did you use to mount it on the fender wells ?


Sent from my iPad using Tapatalk

[2002jm]

:)

What did you use to mount it on the fender wells ?


Sent from my iPad using Tapatalk

used the same screws that are used to mount the clips down at the bottom. They are about 1/2" long.
jm

[Old city bimmer]

Do we have an MTech 1 Thread?

Oh Ok-So what is the blk spot I see in the pic. A grommet or a cover ?
I forgot to send you pic of the clip they use on the factory set up. They use rivets to attach it to the wheel well.

[bradnic]

JMs pics inline

[2002jm]

:)

When I drilled the hole, a chip of paint came off, so I have to fix that. That is a 8mm hex screw that you are looking at.
jm

[Old city bimmer]

What are you doing to prevent rust from starting ?

[2002jm]

:)

What are you doing to prevent rust from starting ?

Going to get some por-15 and go over everything I have drilled into this summer.
jm

[Old city bimmer]

I've been using etching primer and then epoxy primer

[2002jm]

I've been using etching primer and then epoxy primer

yes, that is the way it is suppose to be done:)
Have to take my rear valance back off and then fix the brackets....drill some holes and use the primers like you did. My valance is sitting about 1/2" too low:) and I need to cut the rear end caps so they fit the m-tech kit. Then I will work on the inside of the car:).
jm