Toughest job in an e30?

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • nefarious7907
    replied
    Originally posted by Court M3
    +1 mine died Monday morning and it's cold as hell not to mention headgasket is leaking.
    There is a good writeup for that in the sticky section :)

    Leave a comment:


  • nefarious7907
    replied
    removing the tranny when all of the torx heads are stripped is hands down damn near impossible without pulling the motor.

    Leave a comment:


  • Court M3
    replied
    Originally posted by T3rd Ferguson
    heatercore is next on my list, been putting it off for a year
    +1 mine died Monday morning and it's cold as hell not to mention headgasket is leaking.

    Leave a comment:


  • capucastro
    replied
    The hardest job for me was changing the dashboard of my 325is, in summer at noon, on the driveway and in the middle of heavy rain...

    Leave a comment:


  • Jean
    replied
    Not sure if anybody mentioned, Headliner should be on this list.

    Leave a comment:


  • LivingLegend06
    replied
    Originally posted by Kruzen
    Hell yeah man, that shit took longer than my timing belt
    Thats a bit sad man, I often make simple jobs take longer than they should, but your taking it to the next level with that, but I can relate. I was helping a friend do the wipers on his car once so I took one and he took the other, I had the new one on my side and was sitting in the car laughing while he was trying to figure out how to take the old one off. After about 10 minutes of him failing I had to go out there and do it for him.

    Leave a comment:


  • Kruzen
    replied
    Originally posted by LivingLegend06
    Are you kidding me? I did mine in the parking lot at the auto store in like 3 minutes.
    Hell yeah man, that shit took longer than my timing belt

    Leave a comment:


  • Court M3
    replied
    haven't done many of the jobs you guys talk about but dash swap was definitely the worst!

    Leave a comment:


  • moatilliatta
    replied
    after you've done everything once its a lot easier. Esp the rear sub frame and e brake cables.

    Leave a comment:


  • Axxe
    replied
    Originally posted by rwdrift
    Cooling fan?? Fan clutch or the A/C one? Either one is ridiculously simple. The only complication is on the fan clutch nut which spins, but nothing a chisel can't solve. :)
    Air hammer + fan wrench on it takes it off in about 2 seconds.


    No job is difficult, but the one I dislike the most is rear brake lines with subframe + diff in place. HARD lines. Yeah, it was a bitch, did it on my driveway in -20*C weather with limited tools.
    Last edited by Axxe; 11-20-2007, 12:05 PM.

    Leave a comment:


  • Erick
    replied
    Cooling fan?? Fan clutch or the A/C one? Either one is ridiculously simple. The only complication is on the fan clutch nut which spins, but nothing a chisel can't solve. :)

    Leave a comment:


  • AndrewBird
    replied
    Rear brake lines are tedious, dash is tedious. Nothing really DIFFICULT, but more just a pain in the ass. Have yet to do subframe bushings or rear wheel bearings. Removing the cooling fan can be a pain in the ass if it's stuck.

    Leave a comment:


  • Erick
    replied
    Looks like it was worth every penny Mike. :)

    Leave a comment:


  • mikeedler
    replied
    painting mine was the hardest job.-- cause I took almost everything off of it, including the subframe/suspension

    Leave a comment:


  • moatilliatta
    replied
    Originally posted by e30 gangsta
    the key is to take out the hvac panel. if not youll be there forever.
    we took everything out. it was really tough adjusting it in and out and getting it set into the correct spot.

    Leave a comment:

Working...