If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm figuring the reason for importing a roller would be that it isn't considered a full car, and that VIN's could be "accidently" swapped at some point while the car is in storage.
-Charlie
I believe it is considered a full car for that reason. Plus you still have to register the vin which won't work..
The problem is you can import it in peices like my friend did with his honda powered elises. He brought it in as a "kit" but when it came time for GA dot to inspect, they would not clear it upon inspection. He had to clear them with a buddy in va. one still isn't street legal.
You would spend thousands getting it legal. I wouldn't bother for a few more years when they are legit.
I'm figuring the reason for importing a roller would be that it isn't considered a full car, and that VIN's could be "accidently" swapped at some point while the car is in storage.
just cut off the rear and weld it on to a sedan or couple. No federalizing. Just shipping.
HOLY SHIT, BMW SHOULD MAKE CABRIOS LIKE THAT.
and for the OP: No. the easiest solution by far is to buy one in canada and cross the border, then swap vins. illegal but doable. Or else you are looking at 10+k to get one, especially with the low dollar.
Leave a comment: