Just got some ebay springs

[Wh33lhop]

Some stupid eibach springs
Stock 325i motor
Stupid ricer hot air cone filter intake

Edit: after











I tried going lower, but I didn't like how it looked, and it bottomed out a bit too much. I like where it's at now. I have yet to get an alignment, I'm going to match the front camber to the rear (probably about 2 degrees), max out the passenger's side caster and set the driver's side to .3 degrees less than the passenger's side, and run zero toe or very slight toe in.

[ubernasty]

You threw 5 dead bodies in your trunk don't lie.

[Wh33lhop]

Holy crap you're fast.

[Danny]

Cut a coil or two dude.

[Kershaw]

that front needs to be lower.

[Wh33lhop]

Front will come down a little, honestly I wish I could raise the rear a bit.

[OBEY]

Front will come down a little, honestly I wish I could raise the rear a bit.

add spring pads in the rear :)

[HarryPotter]

Rears perfect, front needs to come down about 3 inches. Get out the blade.

[Mossman]

If the wheels on the car behind you are made by enkei and he has 2 center caps buy/haggle/steal them for me I'll pay $25 each.

[Wh33lhop]

add spring pads in the rear :)

Spring pads present. Guess I could see if I could get some aftermarket ones somehow.

I probably should have held off posting a thread, but I'm going to adjust it tonight, when it's dark, and I was excited.

[StereoInstaller1]

That car be throwing leaves on the lawn, yo!

[xwill112x]

damn dude, reverse rake! mine is lowerr than that. cut a coil and a half up front and i think youll be set.

[Wh33lhop]

Updated with better pics.

Oh, and here are the Eibach springs. ;)





Rates are 450/600, UUC swaybars, 22/19mm with the rear set on soft. I'm looking for a way to use the current UUC endlinks with the M3 endlink tabs on the new struts.

[ak-]

You devil.

[Stephen]

not amused



amused.