If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Went outside (20 degrees) determined to see how it would a snowflake look on the e30. After scraping the inside of a $280 wheel with the caliper, this is what it looks like with a 10MM spacer.
What do you think, sticks out too much, I can try and find some 5MM.
Some one doesn't know what it is like to ball on a budget :rofl: :roll:
Hey J.,
Do you like how it looks? The wheel that I used is the one with the oversized tire, so that makes it look to stickeout more. If I had used one of the streched ones I think it will look nice.
The wheel that I used is the one with the oversized tire, so that makes it look to stickeout more. If I had used one of the streched ones I think it will look nice.
Seriously? You may have owned 2 e30's before but you obviously never learned good taste or common sense.
The tire you have on there is already short enough for your car, going any shorter/stretched will just make you have gobs more wheel gap then you already have.
Plus being an ix its never ever really going to be low just compounding your tire size problem even more.
Seriously? You may have owned 2 e30's before but you obviously never learned good taste or common sense.
The tire you have on there is already short enough for your car, going any shorter/stretched will just make you have gobs more wheel gap then you already have.
Plus being an ix its never ever really going to be low just compounding your tire size problem even more.
Buddy! Relax!
You obviously did not read my introduction on the 1st page, I said I was going to try to FIT these wheels. It does not say I will run these wheels! 15years ago internet was barely going, not many things available for many cars. Were you even driving any car. :yawn:
Comment