Getting Closer!

[Brandon12V]

Been taking what is turning into a full restoration, lol.

Replaced:
Rebuilt Axles
Wheel Bearings front and rear
New hubs
New front control arms, ball joints, tie rods
2000 Rebuilt Z3 rack with IE coupling
Ertalon Cabs and rear subframe bushings
AKG RTABS
VAC aluminum motor and trans mounts
UUC Brakelines
Zimmerman slotted rotors
4:10LSD w e30 m3 cover and Delrin Bushing
rebuilt driveshaft with revshift guibo
Rebuilt head with 272 billet cam & hd rockers
19lb injectors & MarkD chip
IE coolant hoses
Parker push-lock lines and 13"x3" oilcooler
Spal Fan
AC delete
Clutch fan delete
cruiise control removed
trunk tar removed
IE headers
cat delete
h-pipe delete
magnaflow dual in/dual out
south bend clutch & jb racing flywheel
rogue shift kit & UUC selector rod
water pump, timing belt, tensioner
motul fluid everywhere
VR1 oil

Ready to install:
rota 16x8's
front bumper

on the list:
new bilstein rears & GC shock mounts
camber plates
rebuild transmission
stroke that short block

Thanks to everyone on the forum for the assistance thus far! Especially Steve@ blunttech industries, Levant, Bimmerteck, and e30F4R

Cheers.
-Brandon

[Brandon12V]

[bimmerteck]

Looking good sir.

[Mlarsen]

I like! Keep up the good work sir!

[brutus87]

Nice job!
Can I respectfully recommend a chrome kidney?

[Brandon12V]

You can be respectfully denied. :p I am contemplating putting my chrome one back on. just so happens there isn't a single piece of chrome on the car right now, tho.

[downernsp]

I like the progress do work!

[davem]

drool @ mod list

[evoDRichie]

you in indy? we should have gathering of sorts we have about 5 e30s here in terre haute

[Brandon12V]

lol dude, I'm the guy who was blowing up facebook when your car went missing. I posted it on OKI. you should come to cars&coffee @ 96th & meridian tomorrow. starts at 10:30-11ish!

[N2MYE30]

I envy some wrapped headers. Nice.

[evoDRichie]

lol dude, I'm the guy who was blowing up facebook when your car went missing. I posted it on OKI. you should come to cars&coffee @ 96th & meridian tomorrow. starts at 10:30-11ish!

raw thanx ill see what i can do!

[Brandon12V]

You can go ahead and add Eurostop flares to my list of future purchases....

[HarryPotter]

Doesn't look like you will be needing flares at all..

[Brandon12V]

theyll rub in hard corners. oh and the rears are closer to fitting than the front. Front need a spacer or I have to grind down the caliper carriers. not to mention, the rear are always more offset friendly than the front. 16x8 et10 225-50-16 fk452's

idk... hopefully new shocks in the rear will help before I drop the hammer on hacking the fenders.