[emoji1490][emoji1490][emoji1476]
Sent from my iPhone using Tapatalk
''La Quiche'' E30 S54 - Alpha N - BBS E50
Collapse
X
-
Thanks for the picture.
It's a German Auto Solutions rad cap I customized a bit.
Leave a comment:
-
a buddy sent me this... loving the new setup
what radiator cap is that?
Leave a comment:
-
-
-
-
-
Not much, winter is at it's climax here. I must have 4-5' of snow in my backyard and snowboarding is still so fun !
I just sent a payment to Bavarian Restoration for a complete refresh and some add-ons to my cluster. I'm shipping it Monday after work.Leave a comment:
-
This remains one of my favourite threads to check up on. I love everything about it. Keep up the posts!Leave a comment:
-
It's stored outside on jackstand under my carport so I can't really work directly on it. By chance we have snowboard to help to pass the cold season !!
-catch can is not installed. Everything is gonna be clean and good looking again on that side.
-rpm is not working since 2016. I think I'll buy a refurbished SI board with fresh batteries. I'm pretty sure it's the cause.
-interior needs some work. I have to better fit the ECU and put back the glovebox. I'd like to have a black carpet. Black headliner too. Maybe a new steering wheel.
-I may start a custom rollbar
-during the winter I want to buy an AKG mono wiper conversion kit.
-body needs love in the battery area and lower rear valance.
-I had to add 3mm spacers for the front brake to fit. I want to lower this to 1.5mm if possible.
-I need to cut the clutch slave rod a bit. I had to use a Z3M flywheel/clutch/pp combo to keep my G260 and this combo is farter from the engine so closer to the slave. At first my tranny was making all sort of noises I never heard. It took me some time to figure out what was the cause of that. It was always a bit disengaged, very slightly. I tested by shimming the slave but I think it wasn't enough. I'll fine tune it next year.
There's probably many other things I forget, like taking time to enjoy it and going to car shows !!! :DLeave a comment:









Leave a comment: