I was 20" front, 19.5" rear, lower than F34R, still on coils
Alright guys ... lets see some SLAMMED e30s
Collapse
X
-
Brandon, fairly certain I'm as low as you, and I've never considered either of our cars low haha...
That's on a 225/45/15, tucks 1/2" of tire or so all around. Low enough for me, as the front lip and mudflaps sit on the ground, and the oil pan is about an inch off the ground(after being pushed up 1/2").Comment
-
Comment
-
Originally posted by SpasticDwarf;n6449866Honestly I built it just to have a place to sit and listen to Hotline Bling on repeat.Comment
-
just shut up and measure. the rulah dont lie!'89 Delphin 2.8 Cabrio
'94 Yamaha FZR 600
Originally posted by FlexdXJIs that thing on air?Comment
-
Will do it tomorrow, I'll measure off the subframes.
I know you do.
I am as low as I can go on the 5" GC rear springs with adjusters removed. Ordering 4" to replace them, only dropping the rear 1/4''. I would rather have performance over looks.
There is a guy that is running static that looks completely aired out. Looks nuts, but honestly? where could he ever go? Same with your car, sure you are pretty much aired out height, but it came at the cost of looks vs performance. I think a lot of people are confusing r3vlimited for stance works in here...Last edited by F34R; 10-29-2013, 10:18 PM.~ Puch Cafe. ~ Do business? feedback ~ Check out my leather company ~
Instagram: @BWeissLeather
Current cars:
~ '87 325 M30B35 swap
~ '87 535
~ 01 540 Msport 6spd
~ '06 X5 4.8isComment
-
-
Comment
-
Originally posted by RoysneonI have a vert project car that will stay auto until/unless the trans craps out on me. I'm just gonna paint it, slam it and pull bitches.Comment
-
-
I am running within spec sizing to have as much tire contact as I can. Once these are worn out I am fitting 245/35 in the rear. My favorite part is how big of a contact patch I have with the ground. I love to be low and still manage NY roads.
Will do it tomorrow, I'll measure off the subframes.
I know you do.
Fenders are not the best to measure from, I rolled and pulled mine outwards to clear the tires for turning clearance. Subframe is standard across the board except for lowing it on m60 swaps(depends on what route they take).
I am as low as I can go on the 5" GC rear springs with adjusters removed. Ordering 4" to replace them, only dropping the rear 1/4''. I would rather have performance over looks.
There is a guy that is running static that looks completely aired out. Looks nuts, but honestly? where could he ever go? Same with your car, sure you are pretty much aired out height, but it came at the cost of looks vs performance. I think a lot of people are confusing r3vlimited for stance works in here...For all things 24v, check out Markert Motorworks!Originally posted by mbonanniI hate modded emtree, I hate modded cawrz, I hate jdm, I hate swag, I hate stanceyolokids, I hate bags (on cars), I hate stuff that is slowz, I hate tires.
I am a pursit now.Comment
-
Originally posted by SpasticDwarf;n6449866Honestly I built it just to have a place to sit and listen to Hotline Bling on repeat.Comment
Comment