Meet "Blue Nose" M62b44 swap (Pic Heavy)

[DIIRTY-30]

lol.

Had to

[DIIRTY-30]

Picked up some fresh AC Schnitzer's

[DIIRTY-30]

If anyone has caps for the above wheels with the ACS logo on it... PM me. Thx

[ttrreevvoorr]

quit talkin your car up like its tight
at least i fuckin drive mine

[DIIRTY-30]

quit talkin your car up like its tight
at least i fuckin drive mine

Go home lol

[chadthestampede]

I like this a lot. Excellent job.

[DIIRTY-30]

Just waiting on heat shields from Blunt and things will be underway..

[DIIRTY-30]

Well its come time; Finally got the last of my parts thanks to Blunt. Time to get crackin..

Used a HF to pull the drivers side; Inner race stuck to the hub... So i figured fuck it and used my Snap-On air chisel on the passenger side to see how it'd work out and I'm sure you can see the difference in extraction...

















Front heat shields thanks to Blunt

[DIIRTY-30]

Got these in today from Ryan... Thanks again!

____________________

90mm Black Bullet Nose Studs

2pc Hybrid Extended Race Nuts w/Locks

[MyE30]

Just waiting on heat shields from Blunt and things will be underway..

who makes and where did you get this kit?

read though this whole thread the other week and been following ever since. great documentation!

[DIIRTY-30]

who makes and where did you get this kit?

read though this whole thread the other week and been following ever since. great documentation!

Thanks man appreciate it :)

It's just a cheap-y kit that HF makes; bought it as a one time use tool which I don't usually don't do with tools but after doing the rears.. Never again. The large bolt I must say is of really poor quality and isn't hardened, wouldn't recommend using an impact.. Even though it appeared at first you could, carnage.

Here's a link though :

http://www.harborfreight.com/fwd-front-wheel-bearing-adapters-66829.html

[DIIRTY-30]

Pulled the front bearings off... Passenger side looks like it was completely shot, really glad I decided to do this now. SOOOO much easier to do than the rears.

Rented the tool from Vatozone, $32 w/tax; luckily only had to use it on the passenger side. The drivers side came off with my bare hands kinda worried me at first.









Drivers side..



Passenger side..




Passenger side (Top) Driver side (Bottom)



Oh yeah and the heat shields....

[MyE30]

good call on the bearing replacement. wheel bearings are so easy to take for granted. you usually don't think to replace them until they are super noisy.

i found this vid on youtube that was extremely useful for the DIYer that is using the kit that you used.
BMW rear wheel bearing removal with HF tools

[DIIRTY-30]

good call on the bearing replacement. wheel bearings are so easy to take for granted. you usually don't think to replace them until they are super noisy.

i found this vid on youtube that was extremely useful for the DIYer that is using the kit that you used.
BMW rear wheel bearing removal with HF tools

Funny that link is exactly why i figured fuck it and went and bought the kit. EXTREMELY useful, more so than the actual tools themselves haha. I could tell all my bearings were shot though nothing was smooth and you could feel it when you would drive.

[bradnic]

Great vid - used the same one to replace the bearings on my IX. Replaced the splash/heat shields too as you're doing here.

Keep up the great work