If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thats a crazy clean install for a diy. Good work.
What are you doing for extra fuel?
Im using a powerdyne FMU, which raises the fuel pressure 8psi for every psi of boost. I also found out that etas have 19lb injectors stock, so I kept those, they seem to work well so far.
car looks immaculate only thing id change aside from the gasket would be to get some higher profile tires or lower it a tad bit just to get rid of that fender gap
Originally posted by ebelements
Also, for those who don't know, negative camber is the greatest thing since sliced bread(panera). Even tire wear is for city busses and the elderly.
I know the turboed ETA was sold a few months back but did you ever dyno it or make any videos? Im dying to se some results. Also why did you sell it, was there something wrong with it?
Comment