Cant get low enough!

[sticksdaman]

raise the rear a tad add a lip and its titties.. i mean even more than it is now

[BMDub]

They look like Enkei 92's but they are not. Well...they might be.

They could be SSR Reverse Mesh, Very Rare.

[buhnah7]

Add a lip.

The stock iS lip is 3 inches at the sides and like 2 in the middle it will look so much lower

[stevofthahill]

The stock iS lip is 3 inches at the sides and like 2 in the middle it will look so much lower

You're missing the point. He wants to get rid of the wheel gap and tuck some tire, not simply make it "look" lower. BTW car looks sick, and that s13 = ill na na na na.

[mattdk318i]

he should talk to 92MtechnicCabrio. Have you seen his sig?

[E30SPDFRK]

That e36 is hot, I dont like the wheels though. I think ebelements did something with corrado springs and shocks to make his front end lower.

[e30prideTN]

I love both of your cars spastic! When are we going to meet ;) I might see you on the Tail of the Dragon trip if you go. I'm still unsure if I can make it.

[SpasticDwarf]

Thanks everyone.

The 240's wheels are SSR reverse mesh, 16's, I think they're 7.5" wide, -5 offset.

The wheels on the e36 in that pic are a set of drift wheels. My main wheels are Borbet Type A's/HRE C20's.





Thanks for the tips guys. And E30PrideTN, you better make it!

[Turf1600]

I love both of your cars spastic! When are we going to meet ;) I might see you on the Tail of the Dragon trip if you go. I'm still unsure if I can make it.

So, you're gonna be there?

[M42Technik]

So, you're gonna be there?

Keep your dick in your pants. :rofl:

[Turf1600]

Keep your dick in your pants. :rofl:

Believe me - I will. That was in reference to the old "tail of the dragon fund" thread. Good times.

[Skafrog]

get GC or vorshlag camber plates. It lowers your stack height, and stops you from bottoming out your shocks.
I thought we already talked about this?

http://www.vorshlag.com/camberplates.php#perches

http://www.ground-control-store.com/products/description.php/II=142/CA=97

You need to come over and see where my adjuster is set :)

[M42Technik]

get GC or vorshlag camber plates. It lowers your stack height, and stops you from bottoming out your shocks.
I thought we already talked about this?

http://www.vorshlag.com/camberplates.php#perches

http://www.ground-control-store.com/products/description.php/II=142/CA=97

You need to come over and see where my adjuster is set :)

If you get GC camber plates on a GC setup you will have way more suspension travel:

http://e30m3performance.com/installs/GC_susp/GC_susp3.htm

[whiltebeitel]

If you get GC camber plates on a GC setup you will have way more suspension travel:

http://e30m3performance.com/installs...p/GC_susp3.htm

K-Mac and Vorshalg are two different beasts.

[4ce30]

you need to cut the stock spring perch then weld on a new pearch for the GC spindel to sit on.. Then to obtain greatest spring travel/performance you must buy the GC camber plates...
-Brandon