Since you guys love e34's so much.. (e30 content too)

[atle36m3]

nice another sweet ATL bimmer!

[Motorsports]

That thing is SICK. I like everything about it. Good move on the shadowline, but i would put the clears on the front back on and put clears on the back.

[Lucas.B]

that is the best looking m30 bay ive seen. amazing job on the entire car

[TDE30]

Looks good man (especially the engine bay.)

Lose the stretched tires, it's not a Volkswagen.

[Jb325is]

Thanks!

As for the tires... Whatever. I have another set of wheels with 275's on the rear. I usually run 255's on these but I threw a set of 245's on it just for shits.

[CleanAzzE30z]

Shadowline is HANDS DOWN beautiful and much better looking in your case. Ambers dont look that bad.

Mariano

[e34john]

Smoke the ambers up front to match your tails and your good. Car is beautiful. I really want to slam my E34 but then I would have two cars that I have to be careful with when I drive.

[sticksdaman]

I wish my car was as "ugly" as yours

[Zacm829]

Love the stance!

[nando]

nice - I like narrow-kidney E34s soo much better than their ugly wide-kidney'd siblings.

[Erik]

Good lord, I want 17" TSs right meow. They quoted me like $2600 for the size and offsets I wanted... Damn, that looks so nice! Where are the center caps?!

[Jb325is]

Good lord, I want 17" TSs right meow. They quoted me like $2600 for the size and offsets I wanted... Damn, that looks so nice! Where are the center caps?!

They're HRE 505's and thanks! I have HRE caps and some 1/2 caps as well, but the centers need to be milled down for the shorter hexes. I'm also missing a few screws, which are a weird thread spacing and not easy to find. I was running them for a while without all the screws but I almost lost one and I don't want to take that chance again

[vlad]

I like it a lot ! Nogaro silver centers and flat center caps would be tits

[blunttech]

looks really nice. im not a stretched tire fan. would love to see it with 275's on it

[Erik]

They're HRE 505's and thanks! I have HRE caps and some 1/2 caps as well, but the centers need to be milled down for the shorter hexes. I'm also missing a few screws, which are a weird thread spacing and not easy to find. I was running them for a while without all the screws but I almost lost one and I don't want to take that chance again

Same thinggg haha ;)

Looks tatasss.