87' Delphin 325is LS1: Went to Paint

[Rc 415]

test fitted front wheel and brake, looks so good














buuuut i have to figure out a tire, and a massive fender roll in front. rears will get rolled too to fit a 245/45 look at this poke :doh28::bang head:

[Cronopoulos]

Killer rims, flare time!

[dmoney(AB)]

quit test fitting and bolt those suckers on!

new wheels look sick. I can see that you will have a following!

[Rc 415]

Tires are ordered, 225/45/16 falken fk-452 all around. 245/45/16 was too hard to fine in a matching set f/r. Better off this way anyway, I can rotate tires.

Also received these parts yesterday:



Picking up an extra subframe this weekend to install these and put it in the car.

[bmwguy325is]

Are the wheels CCW knock offs?

[Vivek]

I don't think they're actually dual drilled. The other 4 holes look like they're there for weight but I'm not sure.

[Rc 415]

I don't think they're actually dual drilled. The other 4 holes look like they're there for weight but I'm not sure.

This is correct.

[Mlarsen]

So what did you end up doing about that manifold issue? Did you end up purchasing a real Revshift manifold?

[Rc 415]

I'm going to go with a twin scroll manifold, most likely the 666 one. I welded the old one up for now, and it works fine.

[SwiftE30]

those wheels look amazing! where did you get them?

[einstein57]

310mm kit? Any spacers required?

[Rc 415]

310mm kit? Any spacers required?

Negative. Well spacers needed to clear the strut tube with the rim

[einstein57]

How big of a spacer did you use? I'm trying to organize a IE BBK figment guide

[Rc 415]

Tried 5's they weren't thick enough, seems like 10mm will be the ticket. Keep in mind I did not need spacers for the brakes to fit, just to stop the rim inner lip from hitting the strut tube.

[Rc 415]