If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
★ ★ Project Glacier | Make the E30 a Daily Again ★ ★
What I paid for them approximately haha. They'll probably be listed in month or so. I'm just not a huge fan of them to be honest.
I like them, but I don't think I could justify getting them over some bbs rs's unless I got a hell of a deal. I do think they look fantastic on your car though!
I like them, but I don't think I could justify getting them over some bbs rs's unless I got a hell of a deal. I do think they look fantastic on your car though!
In the wheels defense, they are much less played out than RS's :p
I chopped em more around 17s. 16s at that fitment would put you on the ground LOL
Haha! Yeah I wasn't planning on running it any where near that height... Not that I can anyways, I'm at the bottom of my adjusters front and rear as it is now.
Originally posted by SpasticDwarf;n6449866
Honestly I built it just to have a place to sit and listen to Hotline Bling on repeat.
Does this look like it's in an acceptable location?
Here's my selector rod. Is that bend enough to really mess with the shift pattern?
Art gave me a couple selector rods and they both seem to be the wrong type :hitler:
One of them must be an early model one and the other was one used for a 24v swap with a g260 so it has the 10 degree bend and one of the ends is longer... Will the longer end hurt me at all?
I know I should be replacing everything... but I only have two weeks until I have access to a lift so I kinda want to wait until then...
Originally posted by SpasticDwarf;n6449866
Honestly I built it just to have a place to sit and listen to Hotline Bling on repeat.
Comment