Operation: Obtain e30>>SUCCESS>>Initiate project #2

[Spyke]

Lol, it is around the area still... I know that much. I believe it's in good hands, I can only really dream about getting her back again for now though. Life is harsh.

[2mAn]

... Hopefully he will take over this thread when he gets going...

Hopefully OP buys the car back after years and picks up where he left off

[Spyke]

Don't mind me, just looking back in time with heavy regrets. Amazed this isn't locked yet.

[Spyke]

Hung out with the sloth for his birthday:

IMG_2603 by Gregg, on Flickr

IMG_2601 by Gregg, on Flickr

IMG_2603 by Gregg, on Flickr

[Spyke]

Car was sold right before my move to a good buddy (Mickey), and will be receiving a M52 engine swap. Hopefully he will take over this thread when he gets going.

[Spyke]

Link:

http://www.ebay.com/itm/J-M-High-Performance-Fairing-and-or-Rear-Speakers-8-ohm-HSUK-5258-For-Harley-/351020198352?hash=item51ba6f29d0&vxp=mtr

[efficient]

where did you buy those speakers? link

[Spyke]

Put the fronts on

IMG_0741 by Gregg, on Flickr

Also installed new rear deck speakers. In case any one wants something cheap but nice... these are 5.25" 8ohm speakers just like stock. Except poly cones instead of paper. They are J&M speakers from Harley fairings, so they should deal with the sun baking them way better.

IMG_0736 by Gregg, on Flickr

Looks like my good buddy Mickey should be taking the e30 from me before the final move.

[Spyke]

IMG_0613 by Gregg, on Flickr

IMG_0615 by Gregg, on Flickr

[pandaboo911]

I do it all at my sign shop, but I'm leaving that as well to help my parents.

Look up a FastSigns near you, they can help out. Ideally, ask if they can print it on 3M IJ180cV3 or 3M IJ35C vinyl and add laminate

Sweet thanks for the tip

[Spyke]

I do it all at my sign shop, but I'm leaving that as well to help my parents.

Look up a FastSigns near you, they can help out. Ideally, ask if they can print it on 3M IJ180cV3 or 3M IJ35C vinyl and add laminate

[pandaboo911]

Question. Where do you get those vinyls printed? I'm looking to print an artwork on a hood-size piece of vinyl

[Spyke]

Going ahead with the graphics change on the door panels. The M-tech print looks REALLY good.

The car is getting a brand new Suspension Techniques front sway bar as well with all new hardware, bushings, and links too.

[Brian.SHms]

Thanks man! Im hoping to use much of what you did with your car on mine!

[Spyke]

It's literally get a sheet of aluminum or ABS, make a pattern, trace the pattern onto the aluminum or ABS, cut out with a handheld jigsaw, file and sand edges as needed.

Nothing complicated to it, just a good chunk of time.