***CAtuned E30 Mtech1 Build

[catuned]

Looking good guys! Why didn't you remove that balancer from the driveshaft though?

I have one more that was balanced with out the balancer. Might use that one.
Have not decided yet. It's a bit more silent with it.

[MR 325]

Looking good guys! Why didn't you remove that balancer from the driveshaft though?

[catuned]

More work done:

















Rebuilt Driveline


Transmission waiting on a few upgrade parts. Has to be done with the extra power were going to put down.



Brand new Calipers for the back and Pads.

[catuned]

Just checking, when I put my mtech 1 front valance on, the only place I can see that it attaches to the stock sheet metal valance is at the brake ducts, is this correct?
Currently it is not attached there, but it feels really solid

Also why did you cut the metal valance? For intercooler piping?
Mine fit without cutting.

Lastly, do you have a picture of how the fog lights mount to the rear of the front valance? Are they molded into the plastic, or fiberglassed in?
Mine is missing the pieces at the back that hold the actual foglight

thanks :)

Can take some pictures for you next week.

SWEET TITTIES BATMAN! This is awesome

Thanks! lol

[SirWolfian]

SWEET TITTIES BATMAN! This is awesome

[pandaboo911]

Just checking, when I put my mtech 1 front valance on, the only place I can see that it attaches to the stock sheet metal valance is at the brake ducts, is this correct?
Currently it is not attached there, but it feels really solid

Also why did you cut the metal valance? For intercooler piping?
Mine fit without cutting.

Lastly, do you have a picture of how the fog lights mount to the rear of the front valance? Are they molded into the plastic, or fiberglassed in?
Mine is missing the pieces at the back that hold the actual foglight

thanks :)

[catuned]

Unbelievable build Igor. The execution is amazing. Such an inspirational car.

Thank you!

I guess I am not so sure how it fits together, but educate me on why the front housings were cut so short.

It's a sleeve it sits over the existing housing. Same job as Ground Control or any other vendor.

[graphikg]

I guess I am not so sure how it fits together, but educate me on why the front housings were cut so short.

[Javier h]

Props

Unbelievable build Igor. The execution is amazing. Such an inspirational car.

[catuned]

You guys do good work.

Thanks

Looking good Igor.
Did you have the erinforcement plates made or are they off the shelf?

They are made by AKG Motorsports. Ready to weld in. Not very expensive either.

[rav320uk]

Looking good Igor.
Did you have the erinforcement plates made or are they off the shelf?

[e30m3s54turbo]

You guys do good work.

[catuned]

One Step Closer- New Fuel filler neck; Fully Rebuilt Rear End (3.73 Differential) with Renewed Finishes Cover; Reinforced rear control arms; AKG reinforcement plates. Steal Braided Brake Lines!

[catuned]

Next we tackled the coil overs and the Front subframe reinforcements:

[catuned]

Next we started to reinforce the rear shock towers:









After that was done we finished off the 3M spray off: