Wannabe30's s54 swap

[Vtec?lol]

Not bad at all. Loving the progress!

[Neil1138]

Looks great man. Sub'd for more.

[jink0619]

Yes I was going to wait until the motor was in before I bolt up the headers but I will probably bolt me up before as a test fit to make sure there's no issue on the trans. Someone said they had to trim down that ear on the side of the tranny.

What headers did you go with? I'm using eBay and just wondering if you had to cut them up at the end to get them to fit?

I'm also using ebay headers, bought them used and already modified so I assume youll need to im guessing btw.

Sent from my iPhone using Tapatalk

[jink0619]

Since u have access to a lift why not just bolt motor to subframe and side that baby up in there?

[WannaBe30]

Yes I was going to wait until the motor was in before I bolt up the headers but I will probably bolt me up before as a test fit to make sure there's no issue on the trans. Someone said they had to trim down that ear on the side of the tranny.

What headers did you go with? I'm using eBay and just wondering if you had to cut them up at the end to get them to fit?


Sent from my iPhone using Tapatalk

[jink0619]

Nice work so far man, I'm doing the same swap, had issues with dropping motor in with trans and headers attached, so I ended up unbolted them and installed the bare motor.

I havnt installed the sway bar but looks like it needs a custom sway bracket that will bolt up on both side.

Keep up the good work, I'll be in here checking on ur progress since mine will be stopped until I get back in the states.

[328ijunkie]

Epic

[WannaBe30]

I guess I've got far enough and have enough photos to start a build thread so here it goes!

Car: 89 e30 325i


Had an s52 with a zf 5 speed and the plan is to reuse the tranny.

S52 out:



S54:



Of corse doing the rod bearings and it was definitely time:





Decided to delete the power steering:


Egr block off:


Oil cooler adapter for AN fittings:


Crossmember and pan modified by arc asylum:





Pan and crossmember installed:





Engine arms on:



Comparing the z3m s54 arms with the e46 arms:



Installing all the front suspension back:



Can't forget some candy... Lollipops for better exhaust clearance:


The front mount sway bar is not lining up so I called it quits for the night... Not sure what to do about this for now:



Still figuring out what radiator if I even change it out along with coolant hoses and wondering where to install the temp sensor. Thinking about on the thermostat housing but not sure yet.

Also I still need to order a massive booster delete, fuel pump and regulator. But other than that I have everything else needed.

Will post more as I make further progress.


Sent from my iPhone using Tapatalk